Thinklogical Configuring the TLX ASCII Interface Manuel d'utilisateur télécharger pdf (Page 8)

Configuring the TLX ASCII Interface 5 Rev. A - July, 2015

Changing the Command Line Options

The command line options are stored in the file: /etc/default/tlxapi.

The default file contents are:

# Defaults for tlxrapi initscript

# sourced by /etc/init.d/tlxrapi

# installed at /etc/default/tlxrapi by the maintainer scripts

# This is a POSIX shell fragment

## set this to no and the daemon will not run

APIRUN=yes

# Command line options that are passed to tlxrapi.

TLXAPI_ARGS="--verbose –api"

Command line options are added to the TLXAPI_ARGS line.

For example, to change the serial port baud rate to 115200 and send a CRLF at the end of each

line, the TLXAPI_ARGS line will be:

TLXAPI_ARGS="--verbose --api --baud=115200 --CR"

After the file is modified and saved, the following command will restart the API with the new

settings:

service tlxapi restart

Note: Any changes you make to the switch firmware will be lost if you install a new

SD card from Thinklogical.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Pas de commentaire

Thinklogical Configuring the TLX ASCII Interface Manuel d'utilisateur Page 8